Technology, Machinery, Equipments, Service & Spares from one source
  PRODUCTS Inline Filter Holders    


These are ideally suited for inline filtration or sterilization of air or other gases in line systems. Available in 3 sizes viz. 13mm, 25mm and 47mm diameter. The filters can be replaced without detaching the holders when installed in line systems.

Bubble Test Arrangement: Bubble Point Test is a non-destructive test to check the integrity of the membrane filter, before and after the filtration. The bubble points is the pressure required to force air through the pores of a wet filter., If a membrane cannot withstand the pressure below bubble point level, it indicates the leak min the filter. A built-in system for bubble testing can be provided with the membrane holders by in building a set of liquid and air control valves.

Unipack supplies the complete system of membrane filtration equipment including stainless steel pressure vessels, pressure regulators, membrane filters and sterility testing units.

Inline Filter Holder
 
>> Inline Filter Holder (Ø47MM) >> Inline Filter Holder (Ø25mm) >> Inline Filter Holder (Ø13mm)
 

Inline Filter Holder (Ø47MM)

APPLICATION For Sterile Filtration of pharmaceuticals and Biological solutions
CONSTRUCTION Rigid construction with internationally accepted GMP standard.
CAPACITY For 47mm diameter Membrane filters
M.O.C. S.S. 316 / S.S. 316L
FINISH Mirror polished to 220 grit
DESIGN Unipack Filter Holders are decorously designed to support the membranes against the applied pressure differential.
SPECIAL FEATURE For sterilizing small volumes of liquids, small size membrane filter holder.
 
 
Inline Filter Holder (Ø25mm) TOP  
 
APPLICATION For Sterile Filtration of pharmaceuticals and Biological solutions.
CONSTRUCTION Rigid construction with internationally accepted GMP standard.
CAPACITY For 25mm diameter membrane filters
M.O.C. S.S. 316 / S.S. 316L
FINISH Mirror polished to 220 grit
DESIGN Unipack Filter Holders are decorously designed to support the membranes against the applied pressure differential
SPECIAL FEATURE For sterilizing small volumes of liquids, small size membrane filter holders.
   
 
Inline Filter Holder (Ø13mm) TOP  
   
APPLICATION For Sterile Filtration of pharmaceuticals and Biological solutions.
CONSTRUCTION Rigid construction with internationally accepted GMP standard.
CAPACITY For 13mm diameter membrane filters
M.O.C. S.S. 316 / S.S. 316L
FINISH Mirror polished to 220 grit
DESIGN Unipack Filter Holders are decorously designed to support the membranes against the applied pressure differential
SPECIAL FEATURE For sterilizing small volumes of liquids, small size membrane filter holders
 
   
  TOP